User Tips:

With the “crown” of the flute detached, simply place the “O-ring” portion of the ADX10-FLP mic clip at the end of the “head joint” and reattach the crown to the head joint. The APS 911 phantom/battery power supply: The mini-XLRf connector at the end of the ADX10- FL plugs directly into the mini-XLRm connector on the APS-911 power adapter. Next, plug a standard XLR-XLR microphone cable to complete the connection from the APS-911 to the mixing board. The APS 911 has the option to be used in phantom power mode or battery mode. If there is no phantom power available on the mixing console or equipment being used to amplify your signal, use the battery mode to power up the mic. If further reduction of bass frequencies or plosives is needed, the APS 911 is equipped with a base roll-off filter.

Dimensions:

Specifications:

• Transducer Type..................... Pre-Polarized Condenser
• Frequency Response................... 50 Hz - 18 kHz
• Polar Pattern ................Cardioid
• Output Impedance .............250 Ohms balanced
• Sensitivity ................4.5 mV / Pa @ 1k
• Equivalent Noise Level...............25 dB (A weighted)
• Signal to Noise Ratio ..............69 dB
• Power Requirements ........5 - 52 Volts phantom
• Maximum SPL................. ≥120 dB
• Cable/Connector................ Shielded 3’ terminating to a miniature 3 pin Female XLR connector
• Polarity ..............Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3
• Housing/Finish............. Brass /Black E-Coat
• Weight......................... 110 g / 4 ounces
• Length....................... 25 mm / .98 inches