Overview:

DVA S10DP Subwoofer, 18“ Bandpass

The bandpass subwoofer DVA S10 is equipped with a single 18“ woofer of the newest generation, driven by a 1000Wdigitalpower amp.

Using the optionally available flyware, up to two DVA S10DP can be flown mounted to the DRK-10 rigging kit.

Features:

• Cardioid setup with the SDD module
• A cardioid setup comprising the SDD module and two or three DVA S10 subwoofers on each side keeps levels down on stage and affords you far greater control over low-frequency coverage in the audience area.
• Never before has this innovative solution – which until today required much greater effort and more elaborate gear – been so easy to achieve with such professional results.

1) "MAINS FUSE" FUSE CARRIER - Mains fuse housing.

2) “FULL RANGE MAINS INPUT" POWER SOCKET - For connecting the power cable provided.The connector used for mains connection is a POWER CON® (blue)

3) “LINK” RELAUNCH POWER SOCKET - For relaunching the mains power. The output is connected in parallel with input (2) and can be used to power another amplified speaker. The connector uses a POWER CON® (grey)

4) COOLING GRILLE - These grilles permit cooling the amplifier during operation. Do not block accesses and clean the grilles whenever necessary to ensure correct air circulation.

5) " BALANCED MAIN INPUT” INPUT CONNECTOR - Balanced input at line level (0 dBu).It is able to accept “XLR” sockets.

6) "LINK” OUTPUT CONNECTOR - The “XLR” connector connected in parallel with input (5) can be used to send the input audio signal to another amplified speaker.

7) ”BALANCED X-OVER OUTPUT” OUTPUT CONNECTOR - Internal crossover balanced output. The signal from this output can be sent to any other amplified speaker.The crossover frequency can be selected by means of the “SUB X-OVER” switch (8).

8) “SUB X-OVER” SWITCH - This switch permits selection of crossover frequency between the sub woofer and the speakers connected to the ”BALANCED X-OVER OUTPUT” connector.The crossing frequency is selected to 90Hz or 120Hz with a slope of 24dB/oct.The frequency choice depends to the sound reproduction desire.

9) “SUB PHASE ” SWITCH - This switch permits 180° rotation of the audio signal reproduced by subwoofer.Rotation makes for easier optimization of low-frequency reproduction even in the most difficult installation situations. After completing installation, reproduce a piece of music and adjust the switch to obtain the best low-frequency sound.

10) “ON” INDICATOR LIGHT  - The “ON” indicator light comes on green to indicate the amplifier is switched on and it is working properly.

11) “SGN” INDICATOR LIGHT - This indicator comes on green to indicate the presence of the audio signal (at a level  of -20dB).

12) “LIM” INDICATOR LIGHT - This indicator comes on red to indicate that the internal limiter circuit has tripped. This prevents amplifier distortion and protects the speakers against overloads.It is lights for a few seconds during the switching on.

13) “SUB WOOFER LEVEL” INPUT SENSITIVITY CONTROL - This control regulates the sensitivity of the signal at amplifier input. This control does not affect the “LINK” and “BALANCED X-OVER OUTPUT” output levels

14) DIGITAL DELAY “SDD - SUBWOOFER DIGITAL DELAY” OPTION - The DVA S10dp loudspeaker can be equipped with a delay module (SDD - SUBWOOFER DIGITAL DELAY) that allows to delay the sound signal reproduced by the subwoofer. This circuit allows sound-alignment between line array and sub by balancing the various positions. The circuit also includes a balanced “XLR” output that sends the delayed audio

Specifications: