1.) Grill Filter Screws

2.) Ethernet Plug No 1

3.) Ethernet Plug No 2

4.) V/I Meter Channel No 1

5.) Smart card Reader

6.) Function Button No 1

7.) Function Button No 2

8.) Function Button No 3

9.) Function Button No 4

10.) Graphic LCD Display

11.) V/I Meter Channel No 2

12.) Power Switch

AC Main Connection

The AC Main connection is made via the CPC type connector on the rear side of the panel

Connecting Inputs

Input connections are made via the 3-pin XLR-female type or 1/4" phone Jack connectors on the rear side of  the amplifier

Connecting Outputs

Output connectors are made via Neutrik Speakon connectors. Consult the wire gauge chart to find a suitable wire gauge to minimize power and damping factor losses in the speaker cables. The outputs can also work in bridge mode. For each device the 1+ and 2+ pins of Speakon connector are paralleled internally and have to be considered as the positive output of the channel; likewise the 1- and 2- pins of Speakon connector are also paralleled internally and should be treated as the negative output of the channel.

Connecting Remote Control

 You can control the amplifier via the RS485 interface; the illustration shows the wiring configuration for the connection of the data cable to the RJ45 socket located on the rear panel of the amplifier.The same picture shows also the ID selection for Remote Control (in this case ID= 28); to change the ID; rotate the selectors at the desired position.