• Before using the RB2030, the Battery must be fully charged. The battery will take 6–8 hours to fully charge. The battery level meter on the rear panel of your EXPEDITION will show a level only when the AC cord is disconnected.

Instructions for Installation of Battery

1. With the rear of the Expedition cabinet facing you, lie the cabinet face down on a soft surface as not to scratch the front grille. (figure 1)

2. Using a phillips screwdriver, remove the two M4 x 10 lower rear panel screws (to be re-used in step 6) and pole mount thumb screw (figure 1) NOTE: If the cabinet is to be pole mounted, it should be secured to the pole at this time.You will not have access to the pole mounting screw after the battery is installed.

3 .Replace thumb with the M6 x 16 screw (figure 2)

4. Align the battery as in figure 2 and set its legs in the bottom of the EXPEDITION SERIES as in figure 3.

5. Connect the Battery supply cable as in figure 3. IMPORTANT! Both the connectors on the supply cable (from the battery) and plug (on the cabinet) are keyed. Be sure to connect the cable correctly or you’ll risk shorting the battery which may result in fire and or internal amplifier failure.

6. Lift the battery into place and screw the two M4 x 14 screws into the two outer holes and the two M6 x 12 screws in the inner holes on the battery lip. Use the two M4 x 10 screws (from step 2) to secure the bottom of the battery to the cabinet.

Specifications

• Type : 4 x 12VDC, 3.3 Amp/Hours Gel Cell
• Charging time:  6–8 hours

Pin out for Cable and Charger (figure 5)

• Pin 1 NC
• Pin 2 CONTB (control one pin of relay for battery supply on/off)
• Pin 3 CONTA (control another pin of relay for battery supply on/off)
• Pin 4 VDC (Voloatge supply for battery charging)
• Pin 5 AGND (Ground of Charger)
• Pin 6 -VBAT (Negative battery supply to power mon.)
• Pin 7 +VBAT (Plus battery supply to Power mon.)

Dimensions: 8.25 in. (w) x 12.5 (d) x 5.25 (h) 209.5 mm (w) x 317.5 (d) x 133.35 (h)

Weight: 12.8 lbs. 5.8 kg