![]()
1.) Use the 45-mm EQ faders to increase or decrease any one of the 31 frequency bands.Each fader has its own red LED.
2.) Use the FADER RANGE switches to regulate increasing/decreasing in three different levels:+12/-12 dB (green LED), +6/-6 dB (green LED) and 0/-24 dB (yellow LED).
3.) The DEQ1024 features an automatic FEEDBACK DESTROYER.
4.) If you press the FB INDICATOR switch (green switch LED lights up),the FBQ feedbaack detection system is activated.
5.)When you keep the PINK NOISE switch depressed for a few seconds,the internal pink noise generator of your DEQ1024 is activated (red switch LED lights up) and the volume level of the test signal is gradually increased as long as the switch remains depressed (the level is shown on LEVEL METER (13).
6.)In the world of ordinary graphic equalizers,there is always a difference between the adjusted curve and the resulting frequency response.
7.)The BYPASS switch lets you directly compare the processed and unprocessed audio program.
8.)The DYNAMICS section of the DEQ1024 consists of a GATE and a LIMITER.Use the GATE and LIMITER controls to determine the threshold.
9.)The DEQ1024 features a LOW CUT and HIGH CUT filter in its FILTER section,allowing you to limit the entire frequency spectrum upward or downward.
10.)Use the GAIN control in the MASTER section to determine the output volume of the ULTRAGRAPH DIGITAL in the range between -9 to +9 dB.
11.)When you keep the CONFIG switch depressed for a few seconds,you can select the operating mode of your DEQ1024:ANALOG (green LED),DIGITAL (yellow LED),PRE EQ (yellow LED) or POST EQ mode,you can use the rear panel digital connectors as inserts,for example for an additional dynamics processor.
12.)When you keep the CLOCK switch depressed for a few seconds,you can select the desired sample rate with which your DEQ1024 is working:44.1 kHz,48 kHz or 96 kHz (green LED's)
13.) The 12-digit LEVEL METER shows the signal level of the input and output signals.Use the METER switch located below it to select the respective signal,whereby the output signal is indicated when the switch LED lights up (green), and the input signal is indicated when the switch LED is not lit.
14.)Keeping the STANDBY switch depressed for a few seconds puts the DEQ1024 into standby mode (red switch LED lights up.)
15.)The balanced XLR and 1/4" TRS inputs are used for connecting an analog input signal.
16.)The analog output signal of the DEQ1024 can be taken by using these balanced XLR and 1/4" TRS connectors.
17.)The MAX.LEVEL switches increase the maximum signal level on the analog inputs and outputs from +12 dBu to +22 dBu.
18.)You can selectively connect an input signal in the AES/EBU format (via the XLR connector) or in the S/PDIF format (via the RCA connecter) to the digital inputs.
19.)The output signal is available on the digital output in the AES/EBU format (XLR connector) and in the S/PDIF format (via the RCA connector).
20.)The POWER switch powers up your ULTRAGRAPH DIGITAL.It should always be in its "OFF"position when you are about to connect the DEQ1024 to the mains.
21.)The mains connection is achieved via the standard IEC connector.A matching power cord is included.
22.)You can exchange blown fuses that are located in the FUSES COMPARTMENT of your DEQ1024.
23.)Serial Number of the ULTRAGRAPH DIGITAL.Please take the time to fill in and return the warranty card within 14 days after the date of purchase.
![]()
Specifications:
![]()
![]()
