Specifications:

Front Panel Features:

1.) Monitor and Input Sections

2.) Mode Section

3.) Output Section

4.) Use the GAIN control to adapt the signal level perfectly to the circuitry of your ULTRAMATCH PRO.

5.) The PHONES control governs the headphones volume.

6.) This is the stereo 1/4" TRS connector for your headphones

7.) The ANALOG IN and/or ANALOG OUT LEDs indicate which signal is being displayed by the level meter

8.) The SOURCE switch routes the analog input or output signal  to the level meter

9.) LEVEL METER - the signal shown here can always be monitors with the headphones

10.) This LED array displays the sampling rate of the digtal input signal.

11.) The LOCK LED lights up when a valid digital signal - to which the ULTRAMATCH PRO can be synchronized is applied to the active input.

12.) The EMPH LED shows you whether or not the input signal includes an emphasis marker.

13.) The AES/EBU LED lights up when an AES/EBU signal has been applied at the active input connector

14.) Use the SOURCE switch to select the active input

15.) The LED's XLR,RCA and OPTICAL indicate the input activated by the user.

16.) The two LED's SAMPLE RATE CONV and A/D & D/A CONV inform you about the operating of your SRC2496.

17.) Use the MODE switch to switch over between these two operating modes

18.) The SAMPLE RATE switch selects the sampling rate which the input signal is to be converted to or made available at the outputs

19.)  The LED's 32 Khz,44.1 kHz,88.2 kHz and 96 kHz read the sampling rate selected with the SAMPLE RATE switch

20.) The CLOCK switch allows you to select the source determining the sampling rate at the digital output of your ULTRAMATCH PRO.

21.) The PLL LOCK LED shows you that your SRC2496 is processing properly the wordclock signals applied.

22.) The FORMAT switch determines the format of the digital data stream on the output side.

23.) The LEDs AES/EBU and S/PDIF show the adjusted output format which is present at all three digital outputs.

24.) Use the WORDLENGTH switch to select the digital word length of your choice

25)  The LED's  24 BIT,20 BIT and 16 BIT read the word length selected

26.) The DITHER switch enables/disables the dither function

27.)  The EMPH LED lights up when the emphasis bit has been set in the output signal

28.) The COPY switch allows you to set the status of the copy bits in the transmitted data stream

Rear Panel Features:

29.) MAINS CONNECTOR/FUSE HOLDER

30.) SERIAL NUMBER

31.) The BNC connector WORDCLOCK is a high-impedance connector with no internal terminating impedance

32.) The digital XLR output is the standard output connector for  AES/EBU signals

33.) This is the OPTICAL output connector of the ULTRAMATCH PRO

34.) RCA Output

35 - 37 ) DIGITAL INPUTS

35.) The RCA input is the digital standard input for S/PDIF signals

36.) The OPTICAL input is also used for S/PDIF signals

37.) XLR INPUT

38.) ANALOG OUTPUTS - These balanced analog XLR outputs provide the analog signal generated by conversion from a digital format

39.) ANALOG INPUTS - Use these balanced analog XLR inputs to feed in analog line level signals.

Applications